Fuel and air metering
P0113Intake air temperature (IAT) sensor 1 circuit high
OK to drive to a check
What does P0113 mean?
P0113 means the intake air temperature sensor reports an impossibly cold reading. In practice this usually means its circuit is open: an unplugged connector, a broken wire or a failed sensor. On many cars this sensor is built into the mass air flow sensor.
What can cause P0113?
- Sensor unplugged, often after air filter work
- Damaged, loose or corroded wiring or connector
- The sensor itself has failed
Only an inspection can tell which of these applies to your car.
What you might notice
- The check-engine light is on
- Harder starting or slightly rough running in some weather
- Higher fuel use
Can I keep driving with P0113?
OK to drive to a check
The car can usually be driven normally to a workshop. Book a check in the coming weeks, and sooner if anything changes.
What you can safely check yourself
- Think about recent repairs: a part just replaced or a plug left loose is a frequent cause.
- With the engine off and cool, look at the part's plug and wiring for anything loose, broken or chewed. Don't unplug anything while the engine runs.
When to see a technician
Within the next few weeks. It is usually a simple electrical repair once the open wire or connector is found.
General information written with AI help; not yet reviewed by a certified technician. A real inspection is the only way to be sure. Terms of Use
Not sure what your car has?
Describe what you see, hear or feel. AI CarCare helps you understand the likely causes and what to ask before you visit a workshop.
Ask AI CarCare about your carMore codes: Fuel and air metering
- P0087Fuel rail/system pressure too low
- P0101Mass air flow (MAF) circuit range/performance
- P0102Mass air flow (MAF) circuit low
- P0106Manifold absolute pressure (MAP) circuit range/performance
- P0121Throttle/pedal position sensor A circuit range/performance
- P0122Throttle/pedal position sensor A circuit low
- P0123Throttle/pedal position sensor A circuit high
- P0171System too lean (bank 1)