Fuel and air metering
P0106Manifold absolute pressure (MAP) circuit range/performance
OK to drive to a check
What does P0106 mean?
P0106 means the manifold absolute pressure sensor, which measures the vacuum inside the intake manifold, gives readings that don't match how the engine is running. The computer uses this reading to decide how much fuel to inject.
What can cause P0106?
- A cracked or disconnected vacuum hose to the sensor
- An air leak from a cracked vacuum hose or intake gasket
- The sensor itself has failed
- Damaged, loose or corroded wiring or connector
Only an inspection can tell which of these applies to your car.
What you might notice
- The check-engine light is on
- Rough or unsteady idle
- Hesitation or less power when accelerating
- Higher fuel use
Can I keep driving with P0106?
OK to drive to a check
The car can usually be driven normally to a workshop. Book a check in the coming weeks, and sooner if anything changes.
What you can safely check yourself
- With the engine idling, listen for a hiss around the engine and look for cracked or loose rubber hoses.
- With the engine off and cool, look at the part's plug and wiring for anything loose, broken or chewed. Don't unplug anything while the engine runs.
- Think about recent repairs: a part just replaced or a plug left loose is a frequent cause.
When to see a technician
Within the next few weeks. A technician can compare the sensor with a vacuum gauge to see whether the sensor or the engine is at fault.
General information written with AI help; not yet reviewed by a certified technician. A real inspection is the only way to be sure. Terms of Use
Not sure what your car has?
Describe what you see, hear or feel. AI CarCare helps you understand the likely causes and what to ask before you visit a workshop.
Ask AI CarCare about your carMore codes: Fuel and air metering
- P0087Fuel rail/system pressure too low
- P0101Mass air flow (MAF) circuit range/performance
- P0102Mass air flow (MAF) circuit low
- P0113Intake air temperature (IAT) sensor 1 circuit high
- P0121Throttle/pedal position sensor A circuit range/performance
- P0122Throttle/pedal position sensor A circuit low
- P0123Throttle/pedal position sensor A circuit high
- P0171System too lean (bank 1)