Camshaft and crankshaft timing
P0340Camshaft position sensor A circuit (bank 1 or single sensor)
Drive carefully and get it checked soon
What does P0340 mean?
P0340 means the engine computer gets no usable signal from camshaft position sensor A. The computer uses it to time fuel injection and sparks for each cylinder, so starting may take longer or fail.
What can cause P0340?
- The sensor itself has failed
- Damaged, loose or corroded wiring or connector
- Oil leaking into the sensor connector
- A stretched timing chain or a timing belt that has jumped a tooth
Only an inspection can tell which of these applies to your car.
What you might notice
- The check-engine light is on
- Long cranking before the engine starts
- The engine may stall or be hard to start
- Hesitation or less power when accelerating
Can I keep driving with P0340?
Drive carefully and get it checked soon
Drive gently and only as far as you need. Avoid long trips, high speed and heavy loads, and get it checked within days, not weeks.
What you can safely check yourself
- With the engine off and cool, look at the part's plug and wiring for anything loose, broken or chewed. Don't unplug anything while the engine runs.
- On level ground, a few minutes after switching off, check the oil level on the dipstick, and remember when the oil was last changed.
When to see a technician
Soon. If the sensor and wiring test fine, the timing itself should be checked.
General information written with AI help; not yet reviewed by a certified technician. A real inspection is the only way to be sure. Terms of Use
Not sure what your car has?
Describe what you see, hear or feel. AI CarCare helps you understand the likely causes and what to ask before you visit a workshop.
Ask AI CarCare about your carMore codes: Camshaft and crankshaft timing
- P0011Camshaft position A timing over-advanced or system performance (bank 1)
- P0012Camshaft position A timing over-retarded (bank 1)
- P0014Camshaft position B timing over-advanced or system performance (bank 1)
- P0016Crankshaft position – camshaft position correlation (bank 1 sensor A)
- P0017Crankshaft position – camshaft position correlation (bank 1 sensor B)
- P0335Crankshaft position sensor A circuit
- P0336Crankshaft position sensor A circuit range/performance
- P0341Camshaft position sensor A circuit range/performance (bank 1 or single sensor)