Camshaft and crankshaft timing
P0014Camshaft position B timing over-advanced or system performance (bank 1)
Drive carefully and get it checked soon
What does P0014 mean?
P0014 means camshaft B on bank 1, usually the exhaust camshaft, is further ahead than the engine computer expected or is responding slowly to its commands.
What can cause P0014?
- Engine oil that is low, old or of the wrong grade
- A sticking or failed camshaft timing oil control valve (often called the VVT solenoid)
- A worn camshaft phaser
- A stretched timing chain or a timing belt that has jumped a tooth
Only an inspection can tell which of these applies to your car.
What you might notice
- The check-engine light is on
- Rough or unsteady idle
- Hesitation or less power when accelerating
Can I keep driving with P0014?
Drive carefully and get it checked soon
Drive gently and only as far as you need. Avoid long trips, high speed and heavy loads, and get it checked within days, not weeks.
What you can safely check yourself
- On level ground, a few minutes after switching off, check the oil level on the dipstick, and remember when the oil was last changed.
- Write down when it happens: cold or warm engine, speed, weather, and any new noise or smell. This helps the technician a lot.
When to see a technician
Soon. A timing chain or belt that has slipped can get worse and, in the worst case, let the valves hit the pistons. Tell the technician if you hear a rattle from the front of the engine at start-up.
General information written with AI help; not yet reviewed by a certified technician. A real inspection is the only way to be sure. Terms of Use
Not sure what your car has?
Describe what you see, hear or feel. AI CarCare helps you understand the likely causes and what to ask before you visit a workshop.
Ask AI CarCare about your carMore codes: Camshaft and crankshaft timing
- P0010Camshaft position actuator A circuit (bank 1)
- P0011Camshaft position A timing over-advanced or system performance (bank 1)
- P0012Camshaft position A timing over-retarded (bank 1)
- P0016Crankshaft position – camshaft position correlation (bank 1 sensor A)
- P0017Crankshaft position – camshaft position correlation (bank 1 sensor B)
- P0335Crankshaft position sensor A circuit
- P0336Crankshaft position sensor A circuit range/performance
- P0340Camshaft position sensor A circuit (bank 1 or single sensor)