Ignition and misfire
P0327Knock sensor 1 circuit low (bank 1 or single sensor)
OK to drive to a check
What does P0327 mean?
P0327 means the knock sensor's signal is weaker than its normal range, usually because of a wiring or connector problem, or a sensor that has failed.
What can cause P0327?
- Damaged, loose or corroded wiring or connector
- The sensor itself has failed
- A sensor bolt that is loose
Only an inspection can tell which of these applies to your car.
What you might notice
- The check-engine light is on
- Slightly less power and higher fuel use
Can I keep driving with P0327?
OK to drive to a check
The car can usually be driven normally to a workshop. Book a check in the coming weeks, and sooner if anything changes.
What you can safely check yourself
- Use the fuel grade (octane) the owner's manual recommends.
- With the engine off and cool, look at the part's plug and wiring for anything loose, broken or chewed. Don't unplug anything while the engine runs.
When to see a technician
Within the next few weeks.
General information written with AI help; not yet reviewed by a certified technician. A real inspection is the only way to be sure. Terms of Use
Not sure what your car has?
Describe what you see, hear or feel. AI CarCare helps you understand the likely causes and what to ask before you visit a workshop.
Ask AI CarCare about your carMore codes: Ignition and misfire
- P0305Cylinder 5 misfire detected
- P0306Cylinder 6 misfire detected
- P0307Cylinder 7 misfire detected
- P0308Cylinder 8 misfire detected
- P0316Engine misfire detected on startup (first 1000 revolutions)
- P0325Knock sensor 1 circuit (bank 1 or single sensor)
- P0351Ignition coil A primary/secondary circuit
- P0352Ignition coil B primary/secondary circuit