Oxygen sensors
P2271O2 sensor signal biased/stuck rich (bank 1 sensor 2)
OK to drive to a check
What does P2271 mean?
P2271 concerns the oxygen sensor on bank 1 (the side of the engine with cylinder 1), position 2. It means the oxygen sensor reports a rich mixture far more often than expected, even when the computer removes fuel. Sensor 2 sits after the catalytic converter and mainly checks how well the converter cleans the exhaust.
What can cause P2271?
- An ageing or failed oxygen sensor
- A really rich mixture, for example from a leaking injector or high fuel pressure
- A sensor fouled by oil or coolant burning in the engine
- Sensor wiring damaged by exhaust heat or rubbing
Only an inspection can tell which of these applies to your car.
What you might notice
- The check-engine light is on
- Usually no change in how the car drives
- The car may fail an emissions inspection
Can I keep driving with P2271?
OK to drive to a check
The car can usually be driven normally to a workshop. Book a check in the coming weeks, and sooner if anything changes.
What you can safely check yourself
- With the engine off and the exhaust fully cold, follow the sensor's wire along the exhaust: it should not be melted, rubbing on metal or hanging loose.
- Listen for ticking or puffing from the exhaust at a cold start: it can mean a leak near the sensor.
- Ask for every stored code to be read: the other codes stored with it often point to the real cause.
When to see a technician
Within the next few weeks. An oxygen sensor fault is rarely urgent, but a technician should confirm it really is the sensor before replacing it: wiring, exhaust leaks and real fuel-mixture problems can set the same code.
General information written with AI help; not yet reviewed by a certified technician. A real inspection is the only way to be sure. Terms of Use
Not sure what your car has?
Describe what you see, hear or feel. AI CarCare helps you understand the likely causes and what to ask before you visit a workshop.
Ask AI CarCare about your carMore codes: Oxygen sensors
- P0136O2 sensor circuit (bank 1 sensor 2)
- P0137O2 sensor circuit low voltage (bank 1 sensor 2)
- P0138O2 sensor circuit high voltage (bank 1 sensor 2)
- P0141O2 sensor heater circuit (bank 1 sensor 2)
- P0155O2 sensor heater circuit (bank 2 sensor 1)
- P2195O2 sensor signal biased/stuck lean (bank 1 sensor 1)
- P2196O2 sensor signal biased/stuck rich (bank 1 sensor 1)
- P2270O2 sensor signal biased/stuck lean (bank 1 sensor 2)